Ask a Question
Welcome to the MotorForum.RfidEpc.CoM Servo & Stepper Motor Industrial Automation Technology Community Forum


During normal linkage production, the safe mode on the robot teach-in programmer should not hit the ( ) position

+2 votes
57 views

During normal linkage production, the safe mode on the robot teach-in programmer should not hit the ( ) position.

A. Operating mode
B. Edit mode
C. Management mode
D. Safe Mode

by

1 Answer

+2 votes
 
Best answer

Answer: C

Analysis: During normal linkage production, the safety mode on the robot teaching programmer should not hit the management mode position.

by (62.8k points)
selected by

Related questions

+5 votes
2 answers 95 views
95 views
When teaching the robot, the mode knob is hit to teach mode, in which the external device emits a start signal ( )
asked Jul 18, 2023 by Robot manufacturer
+3 votes
1 answer 57 views
57 views
The safety switch on the teach-in programmer is ( ) state when the grip force is too large.
asked Jul 18, 2023 by Teach-in programmer safety switch
+1 vote
1 answer 52 views
52 views
The motion mode on the control cabinet of the MOTOMAN robot NX100 does not have ( ).
asked Jul 6, 2023 by servo motor company (62.8k points)
+1 vote
1 answer 58 views
58 views
The motion mode setting of ABB industrial robots is carried out on ( ).
asked Jul 6, 2023 by servo motor company (62.8k points)
Advertising cooperation:Servo Motor Advertising Cooperation
...